Instruction Manual

11
BEFORE FIRST USE
1. Remove and safety discard any packaging
material, promotional labels and tape from
the cooker.
2. Open the lid by turning the lid knob
counter clockwise and lifting lid up and off
the appliance until it is in the hinged open
position. Unscrew and remove the sealing
nut from the centre of the lid and pull the lid
away to remove from the lid arm.
3. Wash the lid, removable cooking bowl and
silicone lid seal in hot, soapy water, rinse
and dry thoroughly. Wipe the inside and
outside of the base with a soft, damp cloth
and dry thoroughly.
4. Attach the clean silicone lid seal securely
around the wire ring on the underside of
the lid. Adjust position if necessary, so that
it sits comfortably and is free from any
distortions.
5. To reattach the lid, orient the lid so that the
steam release valve housing is to the rear of
the unit, and then align the centre of the lid
with the bolt on the underside of the lid arm
and push into position to expose the screw
thread. Secure the lid by screwing on the
sealing nut so that the red seal touches the
lid surface.
Pressure
Release Valve
Cover towards
rear of cooker
6. Clean and dry the bottom of the removable
cooking bowl and the temperature
sensor, making sure there are no
unwanted materials on the surface. The
removable cooking bowl must sit flat on
the temperature sensor to ensure proper
contact.
7. Click condensation drip cup into place.
8. Insert the connector end of the power
cord into the cooker base, ensuring it is
completely dry. Insert the power plug in to a
230/240 volt (grounded) power outlet.
• Set altitude level (above sea level) -
machine will display Set - Alt -
(distance) - meters
• Press the TIME (+/-) buttons to adjust
to the closest altitude from 0 to 2000
meters.
• Press START to confirm
9. The cooker alert will sound, and the LED
will illuminate.
10. We recommend running a 15 minute
cooking cycle with water to get rid of any
protective substances in the bowl and on
the heating element.
NOTE
The pressure cooker should not be used at
altitudes above 2,000 meters.
Functions