User Manual

16
10. The 1 CUP and STEAM buttons will
illuminate when the machine is ready.
Press the 1 CUP or STEAM button to
resume descaling.
11. When descaling is complete, the 1 CUP and
STEAM button will alternately flash. The
machine will then go into standby mode.
12. Remove and empty the waste water
container. Rinse the drip tray and water tank
and dry thoroughly before replacing them
back onto the machine.
STEAM WAND BLOCKED
During milk texturing, if the machine
detects that the steam wand is blocked, it
will immediately stop operating and the
STEAM button light will be off. Both the
milk temperature and milk foam lights will
fully illuminate and flash. These lights will
flash until a manual steam purge has been
completed.
CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
with a damp cloth.
• If any of the holes in the tip of the steam
wand become blocked, it may reduce frothing
performance. Manually purge the steam
wand to try and clear the holes.
• If the steam wand remains blocked, unscrew
the steam wand tip and use the cleaning tool
to unblock the holes; cleaning tool is located
in the back of the machine, under the water tank.
1
5
3 42
6 !
• Rinse the steam tip and wipe with a clean,
dry cloth. Reassemble the steam wand by
screwing the steam tip back on to the steam
wand. Purge the steam wand after cleaning.
1
5
3 42
6 !
CLEANING THE FILTER BASKETS AND
PORTAFILTER
• The filter baskets and portafilter should be
rinsed under hot water directly after use to
remove all residual coffee oils.
• If the holes in the filter baskets become
blocked, use the steam wand cleaning tool
to unblock the holes.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
should be wiped with a damp cloth to remove
any ground coffee particles.
• Periodically run hot water through the
machine with the filter basket and portafilter
in place, without any ground coffee, to rinse
out any residual coffee.
CLEANING THE DRIP TRAY
• The drip tray should be removed, emptied
and cleaned after each use or when the drip
tray indicator rises through the drip tray grid.
• Remove the drip tray grid and wash both
parts in warm soapy water.
CLEANING THE OUTER HOUSING
• Wipe the outer housing with a soft, damp
cloth and then polish with a soft, dry cloth.
NOTE
Do not use any abrasive cleaners, pads or
cloths which can scratch the surfaces of the
machine.
NOTE
Do not clean any of the parts or accessories in
the dishwasher.