User Manual

15
Care & Cleaning
CLEANING CYCLE
The machine will detect when 300 extractions
have been carried out since the last cleaning
cycle; this will be shown by the 1 CUP and
2 CUP buttons alternately flashing. This
indicates that the group head needs cleaning.
This is a flushing cycle and is separate from
descaling.
To bypass the cleaning cycle; press the STEAM
button. The machine will go back to ready
mode, but will display cleaning alert again the
next time that the machine is turned on.
To perform a cleaning cycle, insert the
provided cleaning disc into the filter basket in
the portafilter. Place a cleaning tablet on top of
the cleaning disc, then lock the portafilter into
the group head.
To enter the cleaning cycle mode, press and
hold the 1 CUP and 2 CUP buttons for 5
seconds. Press any other button to exit the
cleaning cycle mode.
The 1 CUP and 2 CUP buttons will remain
illuminated. Press either the 1 CUP or 2
CUP button to begin the cleaning cycle.
The lights will alternate flashing when the
cycle commences. Once the cleaning cycle is
complete, the machine will go back to ready
mode.
DESCALING
After regular use, hard water can cause
mineral build up in and on many of the inner
functioning components, reducing the brewing
flow, brewing temperature, power of the
machine, and the taste of the espresso.
The machine will indicate that it requires
descaling when the 1 CUP and STEAM
button and the 2 CUP button flash alternately
for 15 seconds. Pressing any of these buttons
will cancel the alert and return the machine
to ready mode.
2L
68oz
DESCALE
1000
WARNING
Do not immerse the power cord, power plug
or appliance in water or any other liquid. The
water tank should never be removed
or completely emptied during descaling.
To descale:
1. Empty the drip tray and re-insert into position
on the machine.
2. Insert the portafilter in the group head.
3. Fill the water tank to the DESCALE line
indicated and add the descaling agent
to the water.
4. Place a 2L / 68 fl.oz container under the
portafilter and steam wand.
5. Turn the machine off by simultaneously
pressing the 1 CUP and STEAM buttons, and
allow it to completely cool before descaling.
6. With the machine off, press the 1 CUP and
STEAM buttons simultaneously for 5 seconds
to enter descale mode.
7. The 1 CUP and STEAM buttons will
illuminate, indicating that the machine
is ready to start descaling.
8. Press the 1 CUP or STEAM button to begin
the descale cycle. These buttons will
alternately flash throughout the cycle.
9. Once the descale solution has been used up,
the descale mode will pause. Refill the water
tank to the MAX line and empty the waste
water container, then replace both parts on
to the machine.