manual

FPP1M0 FPP1M1 FPP1M2

VESA MOUNTS -

LOW PROFILE, SINGLE ARM AND DUAL ARM

Assembly Instructions

Ref. Qty. Part No. Description

AA 12 030-0845 M4 x 0.7 , 20mm Phillips Pan Screws

BB 12 030-1234 M4 x 0.7 , 12mm Phillips Pan Screws

CC 1/2 012-0760 Cable Clips (Beam)

(1) for FPP1M1 & (2) for FPP1M2

(No Cable Clip is used on FPP1M0)

DD 1/2 012-0815 Cable Clip (Pole)

(1) for FPP1M0 & FPP1M1

(2) for FPP1M2

Hardware List

PAGE 1
FPP1M0 FPP1M1 FPP1M2 VESA MOUNTS LOW PROFILE, SINGLE ARM AND DUAL ARM Assembly Instructions Hardware List Ref. Qty. Part No. AA 12 030-0845 BB 12 030-1234 CC 1/2 012-0760 DD 1/2 012-0815 Description M4 x 0.7 , 20mm Phillips Pan Screws M4 x 0.
PAGE 2
BB - (12mm screws) These are used on the outer hole pattern for monitors with a 100mm pattern. AA - (20mm screws) These are used on the inner hole pattern for monitors with a 75mm pattern. These are the main tension screws. They control the pitch of the vesa joint. STEP 1 Attach your monitor to the vesa plate with either screws (AA) or (BB) as indicated above. NOTE: The screws that came with your monitor may be sufficient for mounting to the vesa plate.
PAGE 3
NOTE: 2 different sets of plastic clips are provided for the best possible fit. Fold plastic cable clip closed. Knuckle joints are preset to correct tension. No adjustments are needed. Power cords Feed power cords through clips. Then snap clips into beam’s bottom slots and pole’s slot as shown. Part # 031-7675 Rev. 08.28.