manual

Determine which side you want your shelf to pull out from. Use FIGURE 3 as reference. Attach
the shelf support brackets to either set of holes (depending on your desired height) between the
legs with screws (CC) as shown in FIGURE 4. Then separate each slide and attach the outer
section to the inside of each shelf support bracket with screws (DD) and nuts (EE) as shown in
FIGURE 5. NOTE: Attach rear screw and nut first.
STEP 5
CC
FIGURE 4
FIGURE 5
DD
EE
To access the correct
holes, slide inner piece
out slightly.
Attach rear screw
& nut FIRST.
SHELF SUPPORT BRACKET
These holes need to face the edge
you want the shelf to slide out on.
FIGURE 3
CC
DD
EE