User Manual

ManualsBrandsBresser ManualsCamcorders & DronesTrail Camera

Hanger for

mounting strap

Battery Door

Batteries

Game Camera requires 8 AA batteries.

Insert as pictured.

1. To ensure the chip's initialization process complete,

please wait 4 seconds after install the batteries

before turn on the device.

2. The product requires class 6 or above TF card.

AAx8

Batteries

ON OFF

Micro SD

Card Slot

Mini USB Port

(for viewing and

transferring photos)

On & Oﬀ

Switch

Preview

Buttons

Mounting Strap

USB Cable

Battery Tray

5 MP Lens

IR Lights

Motion Sensor

Nail or Screw Hanger

Preview Screen

Steps for set up , operation, and image viewing

1. Remove Battery Tray

2. Insert Batteries 8 (AA)

3. Insert Battery Tray. NOTE Detail pictures below. You must

insert tray with the curves at the edged of the tray orientated

the correct way. Failure to orientate the tray correctly will

break plastic tabs in the corners of the camera housing which

will reduce the integrity of the camera body.

4. Insert Micro SD Card (up to 32GB) into the Micro SD card slot.

***There is no programming required to set up the camera.***

Turn Camera “On” by sliding the selector switch to the “On” position.

6. The camera screen should show what it in front of the lens as

an image. You can test by looking directly at the lens. You should

see yourself on the “Preview Screen”.

7. After a few seconds you will see a countdown appear that will

countdown from 30 until 0. After the countdown is complete the

camera is on and taking pictures based on movement in front of

the motion sensor.

8. To view pictures recorded by the camera on the micro sd card which is in the camera depress

one of arrows for a few seconds and the camera will switch into a “view mode”. You may

advance the pictures by depressing the arrow keys. When you are ﬁnished previewing pictures

the camera will resume normal operation after no buttons are depressed for a few seconds.

The camera can also be connected to a computer via USB cable. To connect to a computer via

USB cable, slide the on and oﬀ swicth to “oﬀ”. insert the Micro USB cable to the camera and then

to a computer. You will see a connection icon appear on the camera screen. You can now look

at pictures on your personal computer with your favorite JPEG viewer.

9. Mounting can be done with the nylon strap provided or

by screw or nail through the screw or nail hanger located on

top of the camera.

Questions or comments please call

866-252-3811

www.bresserusa.com

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the

equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help.