Technical data

Power Jet-Light 4 x 36 W IP 54

Operating Manual 15 Status: 7201S-07-2007_K

- Regularly check the work lamp for damages.

- The work lamp must be separated from the mains voltage in order for it to be replaced. Pull the

connector from the socket.

- Repairs should be carried out only by authorized personnel.

- Let the work lamp cool down before touching it (for example during replacement of the illuminant).

- Observe a minimum distance of 50 cm on each side to combustible materials.

- Damaged cable line cannot be replaced. The work lamp is to be disposed appropriately.

- Never switch multiple shockproof sockets one after the other.

- Note the secure status of the work lamp.

4 Device overview

Below is a brief overview of the control panel and display of the device and a short functional description.

Pos. Name Pos. Name

1 Retaining bracket 7 Connector

2 Protective shield bolts 8 Supply wiring

3 Protective shied 9 Adjusting screw (Quick release fastener)

4 Illuminant 10 Stirrup bolt

5 Socket 11 Rubber lip

6 Standing bracket