Safety data sheet

Report No.:
NTS15012968M
MSDS
REPORT
Product Name:
Li
-
ion
Battery
Establishment
/
Revision::
Jan.29,
2015
N
owd
T
esting
S
ervices
Co.,Ltd
http://www.nowd.com.cn
Hotline:400
-
088
-
6765
Page
5
of
13
Method of cleaning up: The spilled solids are put into a container. The leaked place is wiped off with dry
cloth.
Prevention of secondary hazards: Avoid re-scattering. Do not bring the collected materials close to fire.
The batteries should not be opened, destroyed or incinerate, since they may leak or rupture and release to
the environment the ingredients that they contain in the hermetically sealed container.
Do not short circuit terminals, or over charge the battery, forced over-discharge, throw to fire. Do not crush
or puncture the battery, or immerse in liquids.
Precautions to be taken in handling and storing
Avoid mechanical or electrical abuse. Storage preferably in cool, dry and ventilated area, which is subject to
little temperature change. Storage at high temperatures should be avoided.
Do not place the battery near heating equipment, nor expose to direct sunlight for long periods.
Other Precautions
Batteries may explode or cause burns, if disassembled, crushed or exposed to fire or high temperatures.
Do not short or install with incorrect polarity.
Arrange adequate protections to avoid possible hurts to the batteries
Keep the batteries in their original packages till when they are used
Do not expose the batteries directly to the sun light
Do not put an higher number of cartons one on another (respect what indicated)
If in the same place are storage batteries with a total capacity > 50,000 Ah, it is suggested to install an alarm
for smoke and gas
If the battery is integral, storage and handle with care, there is any dangers.
It is suggested to handle the batteries in a ventilated place, to don’t smoke, eat or drink during the
assembling.
In case of battery venting, provide as much ventilation as possible. Avoid confined areas with venting
batteries. Respiratory Protection is not necessary under conditions of normal use.
Engineering measures: No engineering measure is necessary during normal use. In case of internal cell
SECTION 8: Exposure Controls / Personal Protection
SECTION 7: Handling and Storage