Operating instructions

6
[Setting the Alarm Time]
Press button  to set the alarm with the auxiliary time. (When pressing button  for the
first time, pressing it continuously for at least 0.5 seconds will cause the auxiliary time to
advance in 1 minute increments. After that, the auxiliary time will advance by 1 minute
each time button  is pressed. Pressing button  continuously causes the auxiliary
time to advance rapidly).
• The following occur when the alarm set time (auxiliary time) is reached:
When using the sound alarm: The alarm sounds for 15 seconds
When using the vibration alarm: the watch vibrates 10 times
After sounding or vibrating, the alarm is switched off automatically, and auxiliary time
switches over to primary time.
* Since the alarm set time is stored in the memory of the watch, when the alarm is
turned on again by pressing button , the auxiliary time will switch over to the set
time stored in memory.
[Switching between sound alarm and vibration alarm]
The alarm notification method switches between the sound alarm and vibration alarm
each time button  is pressed.
• Blue identification mark: vibration alarm
• White identification mark: sound alarm
[Stopping the alarm from sounding or vibrating]
• When the time reaches the alarm set time, the alarm will either sound for 15 seconds
or vibrate 10 times.
Cal AW00_EN 26-09-2003 15:40 Pagina 6