Instruction manual

3
MobileMAX
• Avoid dangerous situations. Do
not use in the presence of
flammable liquids or gases to
avoid creating a fire or explosion
and/or causing damage to this
cooler.
• Avoid any body contact with any
grounded conductor, such as a
metal pipe to avoid possibility of
electric shock.
• Ground Fault Circuit Interrupter
(GFCI) protection should be
provided on the circuit used for
this cooler. Receptacles are
available having built-in GFCI
protection and may be used for
this measure of safety.
• Never drain the air cooler onto
the floor. Connect a hose from the
drain fitting to a drain or gutter.
Water residue could stain or cause
you to slip.
• Always use the correct tools.
Section 1 - SAFETY & Section 2 - ASSEMBLY
WARNING:
The plastic
covering this
cooler
can be a safety
hazard
Please dispose
of thoughtfully.
This column is intentionally left
blank
Removal & Replacement of
Pad Frames
Each pad frame is clipped into the
cooler and is removable by use of
a medium screwdriver inserted into
slots at the base of the sides and
levered downwards (see Fig. 1
,page 4). The side will then slide
down and out of the cooler cabinet.
To replace the pad frame, ensure
that it is the right way up, i.e. with
the water channel upwards.
Then fit the side in and up at the
top and then in at the bottom. Use
the screwdriver again, and insert it
between the bottom of the side and
the pan/tank wall at the center, and
lever upwards, until the side locks
into place.
Fitting the Wheels
Two wheels and two castors (with
brakes) are supplied with each
MobileMAX. They are packed
inside the cooler.
1. Remove the rear pad frame .
2. Remove the package of
castors, wheels and fasteners from
inside the cooler.
3. Carefully roll the cooler onto
one side, onto a piece of carpet or
cardboard so as not to damage the
cooler.
4. Fit the two fixed wheels to the
front of the mobile tank using the
screws provided (screw type). It is
not necessary to drill holes for
these screws. DO NOT
OVERTIGHTEN.
Warning :
Check to be sure that the voltage
rating of the cooler components is
compatabile with your electrical
voltage system