Owner`s manual

MANUAL mode operation
- Press the ON/OFF button.
- Press and hold the SET button and press the MAN/AUTO
button to set the remote control to MAN mode (the
MAN/AUTO button must be pressed within less than 3
seconds of pressing the SET button).
- To turn the heater on use the up arrow button increase the
set temperature above room temperature.
- The display will flash ON and WAIT during the start-up
sequence.
- The flame and fan symbols will appear once the burners
ignite and the room fan starts.
Turning the
heater ON and
selecting
MANUAL
mode
- Press the ON/OFF button.
- The display will revert to OFF mode.
- The room fan will continue to run until the heater has cooled
sufficiently.
Turning the
heater OFF
- Increase set temperature: Press the UP arrow to increase set
temperature by 1
o
C.
- Decrease set temperature: Press the DOWN arrow to
decrease set temperature by 1
o
C.
Adjusting the
room
temperature
When operating in MANUAL mode the heater will turn on and off to maintain the
set temperature until turned off by the user.
Heater operation
- With the SCC on press and hold the FAN button for 3
seconds - the fan speed and fan symbol will flash.
- Press the up or down arrow buttons to adjust to the required
fan speed.
- The SCC will revert to the normal ON state after a few
seconds.
- The fan speed is not user-adjustable in multiple SCC
systems.
Adjusting the
fan speed
The HOME/AWAY button alllows you to set and switch
between two temperature settings as follows:
- When HOME is selected adjust to the required "HOME" set
temperature.
- When AWAY is selected, adjust to the required "AWAY" set
temperature.
- Press HOME/AWAY to switch between these settings.
Using
HOME/AWAY
in MANUAL
mode
5