Owner`s manual

Refrigerated cooler operation
AUTO mode operation
- Press the ON/OFF button to turn the SCC on.
- Press and hold the SET button and press the MAN/AUTO
button to set the SCC to AUTO mode (the MAN/AUTO button
must be pressed within less than 3 seconds of pressing the
SET button).
- If the set temperature is less than the room temperature for
the current time period the cooler will start.
- The SCC will display the time period and run according
to the temperature set for that time period.
- The SCC will automatically advance to the next time
period and operate according to the set temperature for
the new time period.
- The SCC has a built-in 2 minute delay to prevent the
compressor from re-starting within less than 2 minutes of last
turning off - this is to prevent damage to the compressor.
Turning the
cooler ON and
selecting
AUTO mode
- Press the ON/OFF button.
- The display will revert to OFF mode.
- The room fan and compressor will turn off immediately.
Turning the
cooler OFF
- The set temperature can be temporarily adjusted while
operating in AUTO mode.
- Decrease set temperature: Press the DOWN arrow to
decrease set temperature by 1
o
C.
- Increase set temperature: Press the UP arrow to increase set
temperature by 1
o
C.
- At the start of the next programmed time period, the set
temperature will revert to the pre-programmed temperature
you have set for that time period.
Adjusting the
room
temperature
- When operating in AUTO mode the cooler will automatically turn on and off to
maintain the programmed temperature.
- The SCC will automatically advance through the 4 time periods (WAKE, AWAY,
HOME and SLEEP) each day and adjust the set temperature to the pre-
programmed temperature you have set for each time period (see page 6).
Press the HOME/AWAY button to advance to the next time
period. Normal program settings will resume at the end of the
next period. Following is an example of how this can be used:
- If the SLEEP period is programmed to start at 10pm and you
go to bed early at 9pm, pressing HOME/AWAY will bring
forward the SLEEP period settings.
Using
HOME/AWAY
in AUTO mode
R4