Owner`s manual

Refrigerated cooler operation
MANUAL mode operation
- Press the ON/OFF button.
- Press and hold the SET button and press the MAN/AUTO
button to set the remote control to MAN mode (the
MAN/AUTO button must be pressed within less than 3
seconds of pressing the SET button).
- If the set temperature is less than the room temperature
the room fan and cooler compressor will start.
- The snowflake and room fan symbols will appear.
- The SCC has a built-in 2 minute delay to prevent the
compressor from re-starting within less than 2 minutes of last
turning off - this is to prevent damage to the compressor.
Turning the
cooler ON
- Press the ON/OFF button.
- The display will revert to OFF mode.
- The room fan and compressor will turn off immediately.
Turning the
cooler OFF
- Decrease set temperature: Press the DOWN arrow to
decrease set temperature by 1
o
C.
- Increase set temperature: Press the UP arrow to
increase set temperature by 1
o
C.
Adjusting the
room
temperature
When operating in MANUAL mode the cooler will turn on and off to maintain the
set temperature until turned off by the user.
- With the SCC on press and hold the FAN button for 3
seconds - the fan speed and fan symbol will flash.
- Press the up or down arrow buttons to adjust to the required
fan speed - adjustable between 3 and 10 in refrigerated
cooling mode.
- The SCC will revert to the normal ON state after a few
seconds.
- The fan speed is not user-adjustable in multiple SCC
systems.
Adjusting the
fan speed
R3
The HOME/AWAY button alllows you to set and switch
between two temperature settings as follows:
- When HOME is selected adjust to the required "HOME" set
temperature.
- When AWAY is selected, adjust to the required "AWAY" set
temperature.
- Press HOME/AWAY to switch between these settings.
Using
HOME/AWAY
in MANUAL
mode