Owner`s manual

Evaporative cooler operation
Maintenance
Draining water from your cooler at the end of the summer season is not
required if your cooler is fitted with an automatic drain valve system. However
it is a requirement to check the cooler, it's operation, the pump, drain valve,
water level, solenoid and fan motor after the first year and then every two (2)
years as routine maintenance.
If the bleed system is fitted then maintenance should be conducted before and
after every summer season as outlined below.
WARNING: Seeley International recommends that maintenance is carried out by
an authorised service agent. Climbing onto the roof is hazardous and could
result in personal injury or property damage. Failure to have maintenance
carried out may affect your warranty coverage. The following instructions are
provided for you to pass on to your service agent, if required, to ensure that the
correct maintenance is carried out.
End of Season Maintenance
1. Turn off power to cooler.
2. Turn off water to cooler.
3. Remove the pad frame assemblies - take care not to damage the pads.
4. Turn off power switch inside the cooler.
5. Check and clean the lid water channels.
6. If fitted, unclip and remove the bleed system. Allow water to drain. Take care
not to lose the o-ring.
7. Thoroughly clean the tank and pump filter, DO NOT replace the bleed system.
8. Refit the pad frames.
Preseason Maintenance
1. Turn off power to the cooler.
2. Remove the pad frames.
3. Ensure power switch in cooler is off.
4. Gently wash the pads to remove any dust build up during winter. If the pads
are in poor condition, replace them.
5. If removed, replace bleed system and ensure the o-ring is re-fitted.
6. Turn on power switch in cooler.
7. Turn on water and power supply, refit pad frames and run the cooler.
CAUTION: DO NOT RUN COOLER WITH PAD FRAMES REMOVED
7