Owner`s manual

Evaporative cooler operation
Automatic water drain
If an automatic drain valve system has been installed with your cooler, the cooler
will automatically drain the water. This helps ensure the water remains fresh and
helps maintain your cooler in good condition to ensure optimum cooling
performance.
During the drain operation all buttons are in-operative. When the cooler is
re-started, there will be a delay while the cooler tank is re-filled with fresh water.
The drain is activated by the following conditions:
- High water salinity (standard on Braemar and
Breezair models only),
- Pre-set auto-drain time period has expired
(standard Coolair models),
- If the cooler is turned off for a continuous 72
hours (3 days), or
- A manual drain can be initiated at any time by
pressing the UP and DOWN arrow buttons
simultaneously with the SCC off and door
closed. The display will show "dr" to confirm
the operation has activated.
Water bleed system
During cooler operation the bleed system drains a small amount of water from
the cooler to ensure that fresh water is continually added. This is set by your
installer and depends on local conditions. This continuos bleed system is used
where a drain valve is not installed.
6