Owner`s manual

- Your Braemar gas ducted heater uses inbuilt fault diagnosis software to help
determine the source of a fault. If a fault is detected the heater will turn off. In
some cases the heater will automatically attempt to re-start - if the fault still
exists the SCC will flash RESET and a fault code number where the time is
normally displayed.
- If RESET is flashing and a fault code is displayed:
- Open the SCC door and press RESET once - this
acknowledges the fault and turns the SCC and heater off.
- Press RESET again to send a RESET signal to the heater
and turn the heater on.
- If the heater fails to start, wait 10 minutes and repeat the
above steps.
- If the heater still fails to start contact your installer, your
local Braemar service agent, or call 1300 650 644.
Resetting a
fault
Troubleshooting
Heater operation
- If a fault is displayed follow the instructions below and on the following page.
- If you are unable to reset the fault and are requesting a service call please
quote the displayed fault code number - this may enable the fault to be fixed
over the phone.
MON
MAN
ON
ZONE
HEAT
1
2
HOME
NORMAL DISPLAY
MON
MAN
ON
ZONE
HEAT
RESET
RESET
1
2
HOME
DISPLAY WITH FAULT
DETECTED
RESET
FLASHING
FAULT CODE
- The system has detected a fault that requires a
service call.
- Contact your local Braemar service agent or call
1300 650 644.
If a spanner is
displayed
12