Assembly Instructions

3. Before starting the installation, disconnect the power by turning off the circuit
breaker or by removing appropriate fuse at fuse box. Turning the power off at the light
switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity
Detach the circular strap from the backplate and mount the circular strap to the outlet
box in your wall using the two screws provided.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green wire to
green or bare wire or grounding screw on mounting bracket. In all cases grounding
conductor to earth must be used. Use UL/CSA Listed wire connects suitable for the
size, type, and number of conductors. No loose strands or loose wires should be
present. Secure wire connectors with UL/CSA Listed electrical tape.
1. Spread electrical splices so black wires are on one side of outlet box and white
wires on the other.
2. Mount the body of the fixture on the screws protruding from circular strap mounted
on outlet box. The screw will protrude through holes of the back plate of fixture and be
fastened with the decorative knobs. Be careful not to pinch any of the wires between
the fixture and the outlet box.
3. Once the fixture is mounted on the wall, caulk the space between the wall and the
upper area of the back plate to prevent water seeping into the outlet box. Leave the
bottom area un-caulked for drainage of any water which might leak into the enclosure.
4. Installation is complete. Turn on the power at the circuit breaker or fuse box.
Turn the light switch on to activate the fixture.
5. GLASS replacement. unscrew the screws(1) on the middle frame(7) and screws(2)
on the upper cover(3), take away the upper cover,unscrew the screws(4),take away
glass clip(5), pull out glass(6),and then put the replace glass, finally put the glass clip
and upper cover back, secure the screws.
CAUTION: LED fixtures can operate at high temperatures
please use caution when touching during operation or after
operation.