Owner Manual

READ CAREF
ULLY BEFORE INSTALLING FIXTURE
This must be wired in accordance with the National Electrical Code and applicable local
codes.
Warning: pertaining to risk of fire or personal injury.
Keep away from combustables
Turn off/unplug power to change lamp. BE SURE THE POWER IS OFF!
Do not operate if cover shields are damaged or missing on bulbs
Allow fixture to cool down before putting the lamp to the socket.
Do not use lamp indentified for use in enclosed luminaries.
Do not overload transformer or cable rating.
Wiring Instructions
1. Pull the supply wire and the house ground wire out from the OUTLET BOX through the large
center
hole in the CROSS BAR (FIGURE B). Attach CROSS BAR to the OUTLET BOX using
the
MOUNTING SCREWS.
2.Place the WALL CANOPY (FIGURE A) over the OUTLET BOX and onto the fixture's MOUNTING
SCREWS and adjust the fixture MOUNTING SCREWS until they protrude out an appropriate heig
ht
from
the back of the WALL CANOPY to allow the DECORATIVE NUTS to hold the WALL CANOP
Y
tigh
tly against the wall. Remove the WALL CANOPY and secure the position of the MOUNTING
SCREWS against the CROSS BAR.
3.
Place the GASKET (FIGURE A) on the WALL CANOPY and place both over the OUTLET BOX and
onto the MOUNTING SCREWS (which should now protrude throught the WALL CANOPY) and
sure
in pl
ace using the DECORATIVE NUTS. Place O RUBBER RINGS before placing DECORATIVE NUTS
(FIGURE B).
4.
Before connecting your wires, make sure that all power to your installation is OFF!
Now attach the HOUSE GROUND WIRE to the FIXTURE'S GROUND WIRE. Fasten the HOUSE
GROUND
WIRE from the center hold of the outlet box to the FIXTURE GROUND WIRE from
the
CROSS BAR (FIGURE B). Proceed to attach the HOUSE WHITE WIRE to the FIXTURE'S WHITE WIRE.
Fin
ally attach the HOUSE BLACK (or RED) WiRE to the FIXTURE'S BLACK WIRE. Carefully tuck
all
wiring back ino the OUTLET BOX, making sure there are no unexposed/uninsulated wires.
Shad
e Installation:
1.
Place RUBBER GASKET between SHADE and SWIVEL/HEADPIECE, lining up the holes with those
in
the SWIVEL/HEADPIECE. (Note: the ADLXSV930 has a directional shade)
2.
Line up the METAL WASHER inside the SHADE and line up with the holes, keeping
the RUBBER
GASKER and SWIVEL/HEADPIECE aligned.
3.
With all holes lined up, insert the 4 SHADE SCREWS through the METAL WASHER and SHADE and
screw them into the SWIVEL/HEADPEICE to secure the SHADE.
4.
Insert the bulb. See labels on the fixture for maximum wattage - DO NOT USE MORE THAN
MAXIMUM WATTAGE.
5.
Restore power to installation point.
6.
Optional: Adjust SHADE to ideal position.
Clean
ing Instructions:
Caution:
be sure fixture is cool to the touch before cleaning. Be sure the power is OFF.
Clean hood and fixture with mild soap or household type detergent. DO NOT use acid, ammonia or
any other caustic solvent based cleaners.