Phau Ntawv Qhia

6 EN
ATTACHMENT FOR GENTLE HAIR DRYING
(Fig. 1, 2)
• Install the brush attachment (1) or the attachment for
gentle hair drying (6) by aligning the «▼» mark on the
brush attachment (1) or on the attachment for gentle
hair drying (6) with the «
» mark on the body (5), turn
the brush (1) or the attachment for gentle hair drying
(6) clockwise to the « » position, make sure that the
attachments (1 or 6) are securely xed.
• To remove the attachments (1 or 6), press the lock
button (2) downwards, turn the attachment (1 or 6)
counterclockwise to the « » position, release the
button (2).
USING THE HOT AIR BRUSH
• For good results, wash your hair with shampoo, wipe it
with a dry towel, dry with a hairdryer and comb it, then
start styling your hair.
• Unwind the power cord completely.
• Remove the protective cover (4). Make sure that the
installed thermal brush (5) is xed properly.
• Set the operation mode switch (1) into the 0 position.
• Insert the power plug into the mains socket.
• Using the switch (1), select the required operation
mode. When the hot air brush is switched on, the
light indicator (3) lights up:
- «OFF» – hair dryer o󰀨
- «COOL» – supply of «cold air»
- «LOW» – low speed, low air heating temperature
- «MED» – middle speed, middle air heating
temperature
- «HIGH» – high speed, high air heating
temperature
Note: during the rst use, the heating element may
produce a foreign smell and a small amount of smoke,
this is normal and it is not a warranty event.
• Divide the hair into locks.
• Depending on your hair type, select the necessary
operation mode with the switch (3). Use low and
medium air heating temperature for ne hair and high
air heating temperature for thick and coarse hair.
• To straighten a lock of hair, place the brush (1) at the
roots of the hair and slowly brush (1) to the end of the
strand. Straighten the hair on all strands.
• To curl locks of hair, fasten a strand of hair on the
brush (1) and wind it on the brush (1).
• To x the lock of hair, set the operating mode switch
(3) to the «COOL» position – the supply of «cold air»,
after a while remove the curl from the brush (1).
• Switch the hot air styler o󰀨 by setting the operation
mode switch (3) to the position «OFF».
USE OF ATTACHMENT FOR GENTLE HAIR DRYING
(6)
• The attachment for gentle hair drying (6) will allow you
to direct the high-intensity air ow to a specic strand
of hair.
• Install the attachment for gentle hair drying (6) on the