EASY Page 1 of 12
Page 2 of 12
Page 3 of 12
Page 4 of 12
CAMLOCK FASTENER ASSEMBLY INSTRUCTIONS Note: Every cam lock bolt must have a cam lock connector in order to fasten the parts together. { 1} Align the cam connector with its side opening (or arrow) pointing to the small drilled hole. Secure the threded end of the cam bolt by using a screwdriver. Tun right (clokwise) to tighten. (3) (2) Insert the cam lock bolt into the pre-drllled hole above the cam connector. (4) Two parts should fit snugly against each other.
PARTS LIST 7 (1 ) (2) (3) (4) (5) (6) lpc lpc lpc lpc lpc lpc (7) lpc (8) lpc (9) lpc (10) lpc (11) lpc (12) lpc Before you begin,please read"Assembly and Care Advice","Pre-Assembly lntroduction"and "Cam Lock Fastener Assembly Instructions".
Page 7 of 12
Hx4 Ex4 Page 8 of 12 Fx4
Page 9 of 12
Page 10 of 12
Page 11 of 12
ASSEMBLY INSTRUCTIONS SAFETY STRAP TO PREVENT TIP OVER SAFETY STRAP TO PREVENT TIP-OVER Drywall: Select a location where you want the table to be mounted. Place the assembled table against the wall and, on the wall, mark the location where the anchor will be placed. Drill a hole slightly smaller then the size of the screw . Push the anchor as far as it will go with your finger. Tap gently with a hammer until the anchor is flush with the wall surface.
