Installation & Assembly

Label Picture Description QTY

A Table Top 1

B Table legs 4

Label Picture Description QTY

①

Allen Key 1

②

Bolt with Flat Ring

Washer

Table

Caution : You must read this before you proceed

REMINDER : In the event of unsuitability and you intend to return,

please disassemble by reversing the assembly process and do best to

pack to fit into its ORIGINAL CARTON BOX.

PAGE 1
Caution : You must read this before you proceed REMINDER : In the event of unsuitability and you intend to return, please disassemble by reversing the assembly process and do best to pack to fit into its ORIGINAL CARTON BOX.
PAGE 2
Before Beginning Assembly: Step 1 Open the carton and place all the parts onto a clean and soft surface. Place the table top facing floorwards to the ground as shown in the picture.
PAGE 3
Step 2 Put the Table Leg over the tripoint - Screw mount positions. Attach the Bolts with Flat Washer RIngs onto contact point as shown in picture. DO NOT FULLY TIGHTEN THE BOLTS. Step 3 Repeat the same process for the remaining three legs. Once all bolts are in place, begin to tigten in all 12 (twelve) bolts in a sequential manner. Before all the bolts are FULLY driven, turn the table the right way up. Assess and adjust all legs are level with ground. Tighten up all bolts.
PAGE 4
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.