Installation & Assembly

▪ WARNING! Discontinue the use of this electric fireplace if any of the following
has occurred:
o Water damage
o Insert has been damaged or dented
o Power cord has become broken
o Power cord has become too hot to touch
o Insert smokes or smells like smoke (Note: When the heater function
is used for the first time, a slight odor may be present. This is normal
and should not occur again unless the heater is not used for an
extended period of time.)
▪ WARNING! Do not cover or obstruct the insert in any way. The insert will
overheat if covered.
▪ WARNING! Never immerse the product in water or any other liquids.
▪ WARNING! Do not run cables under carpets or rugs. Do not allow the main
cables to hang over the sharp edges of the electric fireplace insert. Do not
allow the main cables to come into contact with hot surfaces. From time to
time, check the cable for damage. Never use the electric fireplace insert if the
cable or any part of the insert shows signs of damage.
▪ WARNING! Do not switch the electric fireplace insert on until it has been
properly installed as described in the instruction manual. Do not leave the
electric fireplace insert unattended during use.
▪ WARNING! Keep the electric fireplace insert out of the reach of children. Do
not let children operate the electric fireplace insert.
▪ The electric fireplace insert is fitted with a safety cut-off which will trigger if
the insert overheats (e.g. due to blocked air vents). For safety reasons, the
insert will NOT automatically reset. To reset the electric fireplace insert,
disconnect the insert from the power supply for at least 15 minutes. After 15
minutes, reconnect the insert to the power supply and switch the insert on.
SAVE THIS SAFETY INFORMATION AND WARNING FOR FUTURE REFERENCE