Assembly Instructions Caution: You must read this before you proceed Please look in the corner of box for hardware packs Extention Table Caution: This Table is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Table and to prevent damage to the Table, two adults are needed to execute this action.
Parts List Label Picture Description QTY A Table Top 1 B Leg 4 C Expansion Board of Table Top 1 Description QTY ① Bolt (M8x60mm) 9 ② Washer 9 ③ Allen Key 2 Hardware Label Picture Assembly Preparation Before Beginning Assembly: 2 ____
Assembly Steps Overview Table Top (A) Expansion Board of Table Top (C) Leg (B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 2 Place Table Top(A) facedown, onto a clean, non-marring surface. Attach Leg(B) to Table Top(A) using Bolts(①), and Washers(②) with Allen Key(③). Do not fully tighten the Bolt. Repeat the same process with the remaining three Legs(B). Step 3 Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface.
Extention Steps: To Extend the Table: Step 1 Unlock the Metal Fasteners. Step 2 With an adult partner, gently pull the Table Top(A) to take out the Expansion Board of Table Top(C) as shown above. Caution: Do not Lean on or apply pressure to the Table Top when it is pulled open. This could cause damage to the product.
Step 3 3.1) Insert the Expansion Board of Table Top(C) to the Table as shown above. 3.2) Gently push the Table Top(A) until the Top Table(A) fits into the Expansion Board of Table Top(C). Caution: Keep hands away from the Table Top(A) and Expansion Board of Table Top(A) when pushing the Table Top to avoid pinching hazards. If you can not push the Table Top(A) inwards, just lightly shake the Table Top(A).
To Retract the Table: Step 1 Unlock the Metal Fasteners. Step 2 2.1) With assistance from an adult, gently pull the Top Table(A) outwards as indicated by the arrows above. 2.2) Take out the Expansion Board of Table Top (C) as shown above. Caution: Do not Lean on or apply pressure to the Table Top when it is pulled open. This could cause damage to the product.
Step 3 Turn the Expansion Board of Table Top(C) and located inside of the Table as shown above. Push the Table Top(A) inwards until both wings of the Table Top(A) align. Caution: Keep hands away from the Table Top(A) and Expansion Board of Table Top(C ) when pushing the Table Top to avoid pinching hazards. If you can not push the Table Top(A) inwards, just lightly shake the Table Top(A). Step 4 Lock the Metal Fasteners under the Table Top(A) into place as shown in the above picture.
____
