Owner Manual - Table

Turn the Table right side up
Ensure all bolts are fully locked into position.
The Table is ready to be used.
Caution: This Table can only be used on a flat, level surface.
Step 3
Place the Table Top (A) with its underside skywards onto a clean, soft surface to avoid any
scratch or damage to the product.
Affix loosely the Legs (B), 2nd into the mounting position at the corners of the Table Top
(A), using the Bolts (①) with Flat Washers (②), with the Allen Key(③), as shown above.
Repeat the same process with the other Leg (B).
CAUTION: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
WARNING ! IF END TABLE IS NOT STABLE , IT COULD LEAD TO DAMAGING THE
PRODUCT.
Step 2
4 of 5