Assembly Instructions

Step 4
Step 5
Step4.1:Attach Seat(A) and Backrest (D)to Left Side Panel(B) using Bolts(②) with Allen Key(③
) as shown above.
Step4.2:Attach Seat(A) and Backrest (D)to Left Side Panel(B) using Bolts(①) with Allen Key(③
) as shown above.
Step4.3:Attach Seat(A) and Backrest (D)to Left Side Panel(B) using Bolts(②) with Allen Key(③
) as shown above.
Do not fully tighten the Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
B
A
C
D
setp4.1
③
A
B
D
C
③
C
D
B
A
setp4.2
setp4.3
③
E
F
②
①
②
Page 4 OF 5
Stand this Chair up.
Put Back Cushion(F) and Seat Cushion(E) on the Chair, stick the velcro from Back Cushion to Seat
Cushion.
Place the Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully sit onto the Chair.
This will help to align all parts at all joints.Then get off the Chair, and in a sequentialmanner,
proceed to tighten all Bolts.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.