Installation Guide

2of2
STEP 6 - Install the Bulb
A. Insert the bulb onto socket
and screw snugly into place.
Your fixture is now
assembled and ready to use.
Enjoy!
Figure 6
Supply
Wires and
Ground Wire
AA
A
BB
CC
Figure 4
STEP 4 - Install the Fixture Chain and Ceiling Canopy
A. Pull the supply wires and ground wire through the Canopy Lock
Ring and the Ceiling Canopy (CC) in order.
B. Connect the Fixture Loop (A) to the Canopy Chain Loop by using the
Quick Link. The fixture will now hang safely.
C. Feed the Supply Wires and Ground Wire through the Canopy Chain
Loop and Nipple into the Outlet Box. Cut the wires leaving
approximately 8” of wire extending from the Outlet Box.
D. Go to Step 4 for wire connections and follow the directions. Return
to Step E in this step when complete with Step 4.
E. Raise the Ceiling Canopy (CC) and Canopy Lock Ring up the Quick
Link and over the Canopy Chain Loop. Tighten the Canopy Lock
Ring onto the Canopy Chain Loop until tight.
Figure 5
STEP 5 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire from fixture
identified with the Label “N”
Black wire from
outlet box (or Red)
Black wire from fixture
identified with the label “L”
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
FINISH: SATIN BRASS
Canopy Lock Ring
Socket
Bulb
(not included)
15” Dia.
21”
5” Dia.
62”