Assembly Instructions Caution : You must read this before you proceed Table Part List Label A Picture Description QTY Table Top 1 Page 1 OF 7
B Table Leg 4 C Support 4 Description QTY ① Bolt (M6 x 35mm) 5 ② Bolt (M6 x 60mm) 9 ③ Screw (M4 x 20mm) 5 ④ Spring Washer 13 ⑤ Washer 9 ⑥ Allen Key 1 ⑦ Screwdriver (Not provided) 1 Hardware Label Picture Page 2 OF 7
Assembly Preparation Before Beginning Assembly: X5 X9 X5 X13 X9 Page 3 OF 7
Assembly Steps Overview This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Place the Table Top(A) facedown on a clean, non-marring surface. Insert the Table Legs(B) into the Table Top(A) and attach using Bolts(②), Spring Washers(④) and Washers(⑤) with Allen Key(⑥). Do not fully tighten the Bolts until all parts has been completed installed. Step 2 2.1) Attach the Support(C) to Table Leg(B) using Bolts(①), Spring Washers(④) and Washers(⑤) with Allen Key(⑥). 2.2) Attach the Support(C) to Table Top(A) using Screws(③)with Screwdriver(⑦).
Step 3 Place the Table on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Table some 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the product freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all parts and gaps reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the Bolts and Screws at all joints.
Page 7 OF 7
