Assembly Instructions

STEP 1 :
Lay out the Desk Tray Parts on the
floor as shown.
STEP 2 : Use the K160 Allen wrench with K110 bolts and K111 barrel nuts (just
like you did on the Bed Case) to build the Desk Tray
STEP 3 : With one person holding the desk tray in place,
Use the K160 Allen wrench to insert the K121B bolt connecting the
4 Desk hinges to the sleeves in the Bed Face.
STEP 4 : Lower the Desk Tray while holding the Bed Face closed.
Use the K113A BOLT and K128 Binding Barrel to connect the
pivot rod support plate to the sides of the Desk Tray
K110
Bolt
K111
Nut
K121B
Bolt
K160
Wrench
K131
Bolt
K128
Barrel
Set up the Desk Tray and Connect to the Bed Face Hinges and the Desk Pivot Rods
Enjoy your new Murphy Deskbed!!! 😊
22