Assembly Instructions

Completing Bed Tray Set-up

K162

BUMPER

K162

Bumper

2 sides

K142

plug

K104B

SCREW

STEP 2A: USING A STEP-LADDER, INSTALL BED TRAY BUMPER ON BOTH SIDES.

FIT THE GUIDE DOWELS INTO THE PREDRILLED HOLES, THEN ATTACH WITH

K104B SCREWS USING A #2 PHILLIPS HEAD DRIVE.

K104A

SCREW

STEP 3A:

TILT THE BED UP AND PUT FOLDED CARDBOARD BETWEEN BED TRAY &

SIDE PANELS (ABOVE THE SAFETY CHAINS) TO SQUARE THE CASE AND

BED TRAY

STEP 3B: INSTALL BRACKETS TO CASE TOP AND STUD AS SHOWN

K123

SCREW

YOUR PENCIL MARK

STEP 1:

LOWER THE BED AND PUT THE FOOT ROD DOWN,

AND THEN FULLY TIGHTEN THE TOP GAS SPRING

LOCK NUT WITH THE K161A WRENCH

USE STEP LADDER SAFETY!

K102

L-BRACKET

STEP 2B: INSTALL WOOD PLUG ON THE EXTERIOR SIDE

PANEL ON BOTH SIDES OF THE BED WHERE THERE IS NO

PIER CABINET