Assembly Instructions

ManualsBrandsBrayden Studio ManualsBedsMunn Queen Murphy Bed

Complete the connection of the Gas Springs

mattress

Flip the foot

rod up

VIEW FROM BOTOM

STEP 1:

PUT THE MATTRESS ON

THE DECK

STEP 2

LIFT END OF BED TO

WAIST HEIGHT AND

FLIP THE FOOT ROD

OVER THE MATTRESS

Use 2 people for this

step as the bed will feel

quite heavy

USE 2 PEOPLE AS SHOWN!

REACH UNDER THE BED TRAY AND FIT THE BOTTOM GAS SPRING HEAD TO THE GAS SPRING

ATTACHMENT POST ON THE BED FRAME AND TIGHTEN COMPLETELY WITH K161A WRENCH

STEP 3:

SLIGHTLY OVER ROTATE

THE BED TRAY ABOUT 1”

TO ALLOW THE

BOTTOM GAS SPRING

HEAD TO ALIGN WITH

THE GAS SPRING

ATTACHMENT POST.

K143

Lock Nut

Gas spring

K143

Lock Nut

Gas

spring

STEP 4:

A NOTE ABOUT STEPS 3 AND 4: While one partner keeps hold of the Bed Tray handles so that the bed does not over-rotate inward too far, nor fall

down to the floor, the other partner can lay down and see the lower piston head and the piston post on the bed frame and instruct the standing partner

to move the bed case ever so slightly into alignment.

Tighten that lower K143 lock nut completely and proceed to step 1 on the next page without delay.