Assembly Instructions

STEP 1 STEP 2
K161B Wrench
K105B Bolt
K106 Fender washer
K153 bayonet connector bar
In boxes #3& #4
TT
TOP TRAY
K153 bayonet
connector bar
WOOD TRAY FACE
INSERT BAYONETS ACCORDING
TO DRAWING WITH SHORT
HORIZONTAL FLANGE UP
K106 Fender washer
K105B Bolt
TT
TOP TRAY
BT
BOTTOM TRAY
INSERT BOLTS AND
WASHERS START BY
HAND AND LEAVE
LOOSE SO THERE IS
SOME “PLAY”
(FROM BUBBLE PACK #3)
Welded Nut
Connecting the Top Tray (TT) to the Bottom Tray (BT).
Step 1: Insert the K153 Bayonet into the TT tray as shown below – with the short leg of the “L” shape up as in the drawing at the bottom
left of this page - then hand start the bolts and leave them loose for now.
Step 2: Now insert the bayonets into the BT tray, and again – hand start the bolts but leave them loose.
11
Insert K105B bolts with K106
fender washers, but leave them
loose so there is some “play”