Installation & Assembly

5. On standing (4,5,6,7) and side-bars (2,2,3,3) fix a black corner (B-01)
according to a headdress of Ø1 mm by means of screws of Ø4x16 (E-02)
according to the picture 5.
6. To the lowrevetted end faces of legs (4,5,6,7) beat thrust bearings with
a nail (G-01) according to the picture 6.
7. On a plain surface put a cover of a table (1) the face in a bottom, put a
collected design on it and connect them between themselves by means of
corners (L-05) according to headdresses of Ø1 mm by means of screws of
Ø4x16 mm (E-02) according to the picture 7.
A-01 x 40
Ø8х35
C-03 x 8
B-01 x 16
Е-02 x 88
Ø4х16
V-01 х 4
J-05 х 8
G-01 х 8
Glue PVA
! Free part of the inserted dowel (A-01) shouldn't act concerning a
detail end face more than on 12 mm.