Owner Manual

4
MOUNTING BRACKET PREPARATION
Mounted To Junction Box
Side View
Junction Box
Remove Knockout Tabs
that Align Junction Box
Mounting Screw Hole
Mounting Bracket
Wall
Mounted To
Junction Box
Front View
Mounted Without Junction Box
Side View
3/8 NM Cable Connect
1/2 Inch Knockout
Not Included
A1
B1 B2
A2
Supply Wire Inside Wall
Wall
Mounting Bracket
Wire Clamp
Only Remove Circular
Knockout Tab To Attach
1/2 Inch Wire Clamp
(not Included)
Mounted To
Junction Box
Front View
Fixture Wall Canopy &
Mounting Plate Act As
An Enclosed Junction Box
For installation with a junction box (See Figure A1 & A2): Remove the mounting pan’s slotted
knockout tabs that align with the junction box screw holes.
For Installation without a junction box (See Figure B1 & B2): Widen the mounting pan’s wire hole by
removing the semi-circular tabs and attach a 3/8 NM cable clamp (not included). Connect the supply
wire to the cable clamp.