Installation & Assembly

ManualsBrandsBrayden Studio ManualsBedsWayde Upholstered Low Profile Storage Platform Bed

Table Of Contents

Upholstered 4 Drawer Storage Bed

ASSembley Instructions

QUEEN SIZE

IMPORTANT NOTES:

Once unboxed, place all parts on a clean & smooth surface (i.e. rug, carpet)

to avoid the parts from getting soiled or marred.

Follow the assembly instructions carefully, step by step.

Do not fully tighten bolts until the end of each step.

After bed is assembled do not attempt to move the bed by sliding or pushing,

attempting to move the bed without removing the mattress and slats, without

assuring the support pieces (legs & bars) have not shifted during the move

WILL RESULT IN THE BED POSSIBLY COLLAPSING, CAUSING BODILY

HARM OR INJURY

IF THE BED HAS EVER BEEN MOVED THE SUPPORT SYSTEM MUST

BE DOUBLED CHECKED TO MAKE SURE NOTHING HAS SHIFTED!

Summary of content (7 pages)

PAGE 1
Upholstered 4 Drawer Storage Bed ASSembley Instructions QUEEN SIZE IMPORTANT NOTES: Once unboxed, place all parts on a clean & smooth surface (i.e. rug, carpet) to avoid the parts from getting soiled or marred. Follow the assembly instructions carefully, step by step. Do not fully tighten bolts until the end of each step.
PAGE 2
Parts List 1 Headboard 1pc 2A Wing(left) 1pc Footboard 1pc 4 5 8 Support Leg(105mm) 2B Wing(right) 1pc Leg(front) 2pcs 6 3 Side Rail 2pcs Leg(back) 2pcs 7 Drawer Units 2pcs 9 Support Leg(285mm) 10 Support Bar(1555mm) 1pc 11 Support Bar(625mm) 4pcs 1pc 8pcs 12 Support Bar(200mm) 4pcs 13 Support Bar(225mm) 2pcs 14 Support Bar(290mm) 2pcs Slat 1set 15 Hardware List A Bolt M8*30mm E Flat Washer M8 I Flat Washer M6 B Allen Key M5 18pcs F Spanner 24pcs J Bolt M8*50mm 30pcs 1pc 1
PAGE 3
STEP ONE: Attach the wings (2A & 2B) to the main part of the headboard (1). See diagram below. STEP TWO: Attach wooden feet to both the bottom of the wings (2A & 2B) and bottom of the footboard (4). See diagram below.
PAGE 4
STEP THREE: Attach the siderails (3A & 3B) to the headboard and footboard. See diagram below. 1 NOTE: The siderails are interchangable, there are no lefts and rights. 3 4 E D A B STEP FOUR: Attach support leg (9) to the headboard support bar (10). See diagram below. Attach the headboard support bar (10) to the bottom of the headboard spanning between the inside of the two headboard wings.
PAGE 5
STEP FIVE: Attach the 4- short support legs (8) to the underside of each drawer cage. See diagram below. STEP SIX: Attach each drawer cage to the inside of the siderails using the 8- M6 bolts (G). Loosely screw in all bolts before completely tightening them. See Diagram.
PAGE 6
STEP SEVEN: Attach the 4- support bars (11) connecting both drawer cages. See diagram below. 1 11 3 7 4 3 11 STEP EIGHT: Attach the 2- 11.5”” support bars (14) connecting to the headboard. See Diagram. Attach the 2- 9” support bars (13) connecting to the footboard See Diagram.
PAGE 7
STEP NINE: Lay down slats. See Diagram.