Installation & Assembly

Step 4
Step 5
Stand the Table up.Place the Table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit onto the Table.
This will help to align all parts at all the joints.Then get off the Table, and in a sequential
manner, proceed to tighten allBolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.If there are still wobbles, loosen the Bolts and execute
the same process.
If the Table is not stable it could lead to damage to the product.
Your Table is ready for use.
ThisTable can only be used on a flat, level surface.
Attach the Side Support Bar(A) to Side Panel(C) and Top Panel(B) Horizontal Base Support
Bar (D) using Bolts(①&②) with Allen Key(③) as shown above.
Do not fully tighten Bolts.
Page 4 OF 5