Caution : You must read this before you proceed Right Sofa Label Picture Description QTY A Side Panel 1 B Back Support Bar 1 C Seat Panel (Labeled with 'face' and 'bottom') 1 D Leg Support Bar 1 E Seat Cushion 2 F Back Cushion 2 1 OF 8
Label Picture Description QTY ① Bolt (M6*20MM) 11 ② Allen Key 1 Before Beginnin g Assembly : 2 OF 8
Overview Back Cushion(F) Back Support Bar(B) Side Panel(A) Seat Panel(C) Seat Cushion(E) Leg Support Bar(D) FRONT FACING This Sofa has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Sofa parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all the parts onto a clean, non-marring surface.
Step 2 Place the Side Panel(A) with its inside facing up. Insert Seat Panel(C) into the Side Panel(A). Step 3 3.1) Attach the Seat Panel(C) to Side Panel(A) using Bolts(①) with Allen Key(②) as shown above. 3.2) Attach the Seat Panel(C) to Side Panel(A) using Bolts(①) with Allen Key(②) as shown above. Do not fully tighten Bolts.
Step 4 4.1) Remove the plastic plugs( prevent the alum tube was scratched) in the both ends of Back Support Bar (B) using Allen Key(②) as shown above. 4.2) Insert the Back Support Bar(B) into the Side Panel(A). Step 5 A Attach the Back Support Bar(B) to the Side Panel(A) using Bolt(①) with Allen Key(②). Do not fully tighten Bolt.
Step 6 Insert the Leg Support Bar(D) into the Back Support Bar(B) and Seat Panel(C) as shown above. Step 7 7.1) Attach the Leg Support Bar(D) to Back Support Bar(B) and Seat Panel(C) using Bolts(①) with Allen Key(②) as shown above. 7.2) Attach the Leg Support Bar(D) to Seat Panel(C) using Bolt(①) with Allen Key(②) as shown above. Do not fully tighten Bolts.
Step 8 Stand the Sofa up. Place the Sofa on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and carefully, sit onto to the Sofa. This will help to align all parts at all the joints. Then get off the Sofa, and in a sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. This may cause the frame to warp.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
