Installation & Assembly

Step 5
Attach Pressure Hinge on Lid-Top Panel(E) to the mounting position inside the Back Panel(B)
using Bolt(⑤), PVC Gasket(⑦), Washer(③) and Nut(⑥) with Wrench(②) and Allen Key(①) as
shown in the picture.
Tighten all Bolts at all joints fully in a sequential manner.
Spread out the Inner Lining(F).
Place it into the Trunk.
Then smooth out the corresponding Velcro tapes until all tapes meet and seal securely.
There is a hole in the Lining that should be aligned to the Pressure Hinge.
Your Storage Trunk is ready for use.
This Storange Trunk should only be used on a flat, level surface.
Step 7
Step 6
Page 5 OF 6