Owner Manual

7
CEILING
COVER
6
" DOWNROD
Figure 6
3. Ceiling Fan Assembly (Continued)
3.7
Route the 80” Black and White Motor Leads through the
Ceiling Cover (Figure 6).
Place the Ceiling Cover over the Downrod. Be sure both
the Ceiling Cover and the Coupler Cover are oriented
correctly (Figure 6).
HANGER
BALL
SET SCREW
PIN
6" DOWNROD
Figure 7
3.8
NOTE: Only use the Hanger Ball supplied with this
Ceiling Fan.
Route the two 80” Motor Leads through the Hanger Ball.
Reinstall the Hanger Ball (Figure 7) on the Downrod as
follows:
Position the Hanger Ball Pin through the two Holes in the
Downrod and align the Ball so the Pin is captured in the
Groove in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and securely
tighten the Set Screw in the Hanger Ball.
NOTE: A loose Set Screw could create Fan wobble.
HANGER BALL/
DOWNROD
ASSEMBLY
WHITE WIRE
BLACK WIRE
1/2-INCH
6 TO 9
INCHES
Figure 8
3.9
The Fan comes with Black and White Leads that are
80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 8).
Cut off excess Leads and strip back insulation 1/2-inch
from end of Leads.
You have now completed the initial assembly of your new
Ceiling Fan. You can now proceed with hanging and
wiring your Fan.