Owner Manual

6
6" DOWNROD
CLEVIS
PIN
HAIRPIN
CLIP
MOTOR
COUPLING
HAIRPIN
C
LIP
CLEVIS
P
IN
LOOSEN SET
SCREWS (2)
MOTOR
COUPLER
Figure 3
3. Ceiling Fan Assembly (Continued)
3.4
Loosen the two Set Screws in the Motor Coupler.
Place the 6” Downrod into the Motor Coupler, aligning the
Clevis Pin Holes in the Downrod with the Holes in the
M
otor Coupler (Figure 3).
The Clevis Pin must go through the Holes in the Motor
Coupler and the Holes in the Downrod.
Be sure to push the straight leg of the Hairpin Clip through
the Hole near the end of the Clevis Pin until the curved
portion of the Hairpin Clip snaps around the Clevis Pin.
The Hairpin Clip must be properly installed to prevent the
Clevis Pin from working loose.
Pull on the Downrod to make sure the Clevis Pin is
properly installed.
6" DOWNROD
RETIGHTEN SET
SCREWS (2)
MOTOR COUPLER
3.5
While pulling up on the 6” Downrod, retighten the two Set
Screws (previously loosened) in the Motor Coupler to
secure the Downrod into place (Figure 4).
NOTE: The Set Screws must be properly installed as
described above, or fan wobble could result.
6" DOWNROD
MOTOR
HOUSING
COUPLER COVER
COUPLER COVER
GROMMET
Figure 5
3.6
Route the 80” Black and White Motor Leads through the
Coupler Cover (Figure 5).
Make sure the Grommet is properly installed in the
Coupler Cover then slide the Coupler Cover on the
Downrod until it rests on the Fan Motor Assembly
(Figure 5).
It is critical that the clevis pin in the motor coupling is
properly installed. Failure to verify that the pin is properly
installed could result in the fan falling.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly installed
could result in the fan falling.
WARNING
!
Figure 4