Owner Manual

3-WAY INSTALLATION
(One fan controlled by two different Wall Controls)
(See Figures 36 and 37).
9.9
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
9.10
At all Wall Box locations remove Faceplates and Screws
from existing Controls. Pull Controls out from Wall Boxes
and determine which Wall Box contains the “hot” Lead and
which Wall Box contains the “load” Wire. Also, identify
Traveler Wires which are common to both Wall Boxes.
Disconnect Wires from Existing Controls only.
Do not attempt to disconnect any Wires not already
connected to Existing Controls.
9.11
Before installing the Wall Control, place the Wall Control in
“OFF” mode by pushing “ON/OFF” Switch to the “OFF”
position.
9.12
Install a Wall Control in the Wall Box containing the “hot”
Wire first. Connect the Black Wire of the Wall Control to the
“hot” Wire. Securely connect the Wires with Wire
Connectors supplied.
9.13
Connect the other Black Wire of the Wall Control to both
remaining Traveler Wires in the Wall Box and secure with
Wire Connector supplied.
HOT
BLACK
F
AN/LIGHT
W
ALL
C
ONTROL
TRAVELER
WIRE
BLK BLK
LOAD
GROUND
NEUTRAL
BLACK
BLK
RECEIVER LOCATED WITHIN
THE MOTOR HOUSING
Figure 36
Turning off wall switch is not sufficient. To avoid possible
e
lectrical shock, be sure electricity is turned off at the
main fuse or circuit breaker box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
9. Wall Control Installation (Continued)
22