Owner Manual

21
9. Wall Control Installation (Continued)
9.3
Before installing the Wall Control, place the Wall Control in
“OFF” mode by pushing “ON/OFF” Switch to the “OFF”
position.
9.4
Connect one Black Wire of the Wall Control to the “hot”
Wire. Securely connect Wires with Wire Connectors
supplied (Figure 35).
9.5
Connect one Black Wire of Wall Switch to the “load” (black)
Wire in Wall Box. Securely connect Wires with Wire
Connector supplied.
9.6
Screw the Wall Control into Wall Box using the supplied
Screws. Leave the Wall Control in “OFF” mode until Fan
installation is completed.
9.7
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that best
suits your needs and snap the Cover onto the Wall Control
(Figure 35).
9.8
Install Decorator Wall Plate using the two Screws provided
with Wall Plate. Leave the Wall Control in “OFF” mode until
Fan installation is completed (Figure 35).
FAN/LIGHT WALL
CONTROL
WALL BOX
BL
ACK
BL
K
H
O
T
SWITCH COVER
DECORATIVE WALL PLATE
SCREWS (2)
NEUTRAL
WIRES
T
O
1
2
0
V
A
C
S
O
U
R
C
E
T
O
L
O
A D
G
R
O
U
N
D
Figure 35
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!