Owner Manual

To avoid possible fire or shock, make sure that the

electrical connector are completely tucked inside the

lower housing and not pinched by the no-light cover.

WARNING

7. Optional Installation of No-Light Cover (Continued)

7.4

Carefully tuck the Fan Motor 2-Pin Wire Connector up

close into the Lower Housing (Figure 32).

Place the No-Light Cover onto the Lower Housing aligning

the three flat areas on the top flange of the No-Light Cover

with the three dimples on the inside of the Lower Housing

(Figure 32).

Then turn the No-Light Cover clockwise until it stops

turning.

Your No-Light Cover is now installed.

ROTATE NO-LIGHT COVER CLOCKWISE TO

ENGAGE ON

THE LOWER HOUSING DIMPLES

LOWER

HOUSING

LIFT NO-LIGHT COVER UP INTO

LOWER HOUSING ASSEMBLY

FLAT AREA

NO-LIGHT COVER

Figure 32

7.3

Disengage and retain the Fan Motor 2-Pin Wire Connector

from the 2-pin Wire Connector of the LED Light Fixture

Assembly (Figure 31).

NOTE: Store the LED Light Fixture Assembly in a safe

place for future use, if needed.

DISENGAGE LIGHT

FIXTURE ASSEMBLY

2-PIN WIRE CONNECTOR

LED LIGHT FIXTURE

ASSEMBLY

DISENGAGE FAN

MOTOR 2-PIN WIRE

CONNECTOR

Figure 31