Owner Manual

6. Final Assembly (Continued)

6.11

Place the Glass into the Lower Housing, aligning the three

flat areas on the top flange of the Glass with the three

Dimples in the Lower Housing.

Then turn the Glass clockwise until it stops and is secure

(Figure 28).

NOTE: Periodically check that the Glass is seated fully

clockwise in the Lower Housing.

Installation of your Ceiling Fan is now complete.

Proceed with installation of the Wall Control, Section 8.

LOWER HOUSING

DIMPLES (3)

ROTATE GLASS CLOCKWISE TO

ENGAGE ON

THE LOWER HOUSING DIMPLES

LIFT GLASS UP INTO

LOWER HOUSING ASSEMBLY

FLAT AREA

OF GLASS (3)

GLASS

Figure 28

6.10

nstall the LED Light Fixture Assembly onto the Lower

Housing by aligning and engaging the keyhole slots of the

LED Light Fixture Assembly with the loosened screw

heads on the Lower Housing (Figure 27).

Rotate the LED Light Fixture Assembly clockwise to

engage the two loosened Screws.

With the LED Light Fixture Assembly locked into the

keyhole slots, tighten the two previously loosened Screws.

Reinstall the #6-32 x 3/8” Truss Head Screw with

Lockwasher (previously removed) into the LED Light Fixture

Assembly (Figure 27).

REINSTALL ONE #6-32 x 3/8"

TRUSS HEAD SCREW WITH

LOCKWASHER

LED LIGHT FIXTURE

ASSEMBLY

LOWER

HOUSING

ROTATE LED LIGHT FIXTURE ASSEMBLY CLOCKWISE

TO ENGAGE THE TWO LOOSENED SCREWS

Figure 27

A spare #6-32 x 3/8” Truss Head Screw with Lockwasher

is provided in parts bag, if needed.