Owner Manual

14
6. Final Assembly (Continued)
6.7
Pass the Fan Motor 2-Pin Wire Connector through the
center hole of the Lower Housing.
Install the Lower Housing onto the Fan Motor Assembly by
aligning and engaging the keyhole slots of the Lower
Housing with the loosened screw heads on the Fan Motor
(Figure 24).
Rotate the Lower Housing clockwise to engage the two
loosened screws.
With the Lower Housing locked into the keyhole slots,
tighten the two previously loosened Screws.
Reinstall the #6-32 x 3/8” Truss Head Screw with
Lockwasher (previously removed) into the Lower Housing
(Figure 24).
A spare #6-32 x 3/8” Truss Head Screw with Lockwasher
is provided in parts bag, if needed.
ROTATE LOWER HOUSING CLOCKWISE
TO ENGAGE THE TWO LOOSENED SCREWS
REINSTALL ONE #6-32 x 3/8"
TRUSS HEAD SCREW WITH
LOCKWASHER
LOWER HOUSING
Figure 24
To avoid possible fire or shock, do not pinch wires
between the fan motor assembly and the lower housing.
WARNING
!
6.6
Remove one of the three #6-32 x 3/8” Truss Head Screws
w
ith Lockwashers from the Fan Motor Assembly
(Figure 23). Retain the Screw for future installation.
L
oosen the other two Screws several turns.
REMOVE ONE #6-32 x 3/8"
TRUSS HEAD SCREW
WITH LOCKWASHER
F
AN MOTOR
A
SSEMBLY
Figure 23