Assembly Instructions

STEP 1

Take out Assembly Instruction sheet, Hardware Pack and

Feet Packaging from the Drawer which marked with the rope.

"BR" & "BL" Marking

at bottom of the Unit

& top of the Leg

"FR" & "FL" Marking

at bottom of the Unit

& top of the Leg

STEP 2

Align & fasten feet (B),(C),(D) and (E) to Unit according to the position left and right follow the label correctly using

bolt (G), lock washer (H) and flat washer (I) and fully tighten with Allen Key (J). Align and tighten Support Leg (F)

with leveler to bottom panel of unit (A) by turning center feet with leveler clockwise until tight.

Support Leg

NO HARDWARE LIST

Front Right Feet

Front Left Feet

NO PARTS LIST

Rear Right Feet

Rear Left Feet

Dresser

REVISION : A

Allen Key M4

JCBC M6 x 35mm

SpringWasher

Washer Ø

" x 20mm

ASSEMBLY INSTRUCTIONS

PAGE 1
ASSEMBLY INSTRUCTIONS STEP 1 Take out Assembly Instruction sheet, Hardware Pack and Feet Packaging from the Drawer which marked with the rope.
PAGE 2
ANTI TIPPING HARDWARE IDENTIFICATION PARTS IDENTIFICATION A. DRESSER 1. 1 SET 2. 1 Pc 50mm Screw 3. 1 Pc Tie Strap 4. This anti-tipping kit must be attached to a wall using the provided 50mm screws. 1 Pc 16mm Screw 2 Pcs L Bracket Step 2: Attached the second bracket securely to the wall using the provided longer 50mm screw, through the smaller hole of the bracket. Please attach the second bracket to the wall 2 inches lower than the first bracket that was attached to the back of the dresser.