Assembly Instructions

3-Bag Laundry Sorter with Hanging Bar
Package Contents
Assembly Instructions
STEP 1. Connect Horizontal Tube (L), Metal Tube
Frame (A) and Plastic Washer (M) with screws (G). Use
Wrench (H) to tighten the screws.
STEP 2. Screw wheels (I) into the bottom of metal tube
frame (A). Make sure that the locking wheels are on the
same side.
NOTE: Check to ensure you have two non-locking and
two locking wheels. Check that locking mechanism works properly.
Screw wheels stem completely into bottom of metal tube frame.
Tighten securely.
A. Metal tube
frame x 2
B. Grid Shelf x 1
F. Middle Plastic
Adjuster x 2
E. Top Plastic
Joint x 2
G. Screws x 8
D. Wire
Handle x 6
STEP 3. Put Grid Shelf (B) onto the bottom horizontal
tube (L). Keep grid shelf (B) lip down.
STEP 4. Insert Wire handle (D) through the loops of
bag (C), then place on the horizontal tube (L).
Safety Information
1. Two adults are recommended for ease of assembly. Use care when handing.
2. Assembly recommended on a soft surface, such as carpet, to avoid scratching flooring finish.
3. Discard the black circular plastic pieces. These are used to separate the shelves for shipping purpose.
CAUTION: Do not allow children to climb or play in or
around the shelves.
C. Bag x 3
I. Wheels x 4
(2 locking, 2 non-locking)
H. Wrench x 1
STEP 5. Unscrew the thumb screws of Middle Plastic
Adjuster (F) then put on the pole of metal tube frame (A).
STEP 6. Insert the Upright Bar (K) into the middle plastic
adjuster (F) and screw the thumb screw.
NOTE: These thumb
screws serve as the locking mechanism for the extension of the
upright bar. Make sure two upright bars are in the same height.
STEP 7. Put two ends of Hanging Bar (J) into the hole of
Top Plastic Joint (E) and keep another hole vertically
downward, then insert them into the upright bar (K).
J. Hanging
Bar x 1
K. Upright
Bar x 2
L. Horizontal
Tube x 4
M. Plastic
Washer x 8
K
K
E
J
F
A
F
C
L
D
B
L
I
A
A
L
H
G
M