Installation & Assembly

FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 2)
3. Remove the Allen screw (B1) with Allen wrench (F1) from the xture.
4. Drill a hole in the wall aligned with the key-hole located in the mounting plate, insert the plastic anchor (C1).
CONNECTING THE WIRES (Fig. 2)
5. Connect the driver input wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to
the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
6. Secure the mounting plate to the junction box using the junction box screw (G1). Fasten the mounting plate to the wall using the wood
screw (D1). The side of the mounting plate marked “GND” must face out.
MOUNTING THE FIXTURE (Fig. 1)
7. Remove the mounting screw (E1) from the xture, insert
crystal glass to the xture.
8. Place the cover on the crystal glass; secure it with mounting screw (E1).
Be careful not to screw it too tight to break the crystal.
9. Secure the xture onto mounting back plate with the Allen screw (B1)
using Allen wrench (F1).
Back Plate Dimensions
11”
1 3/8”
1 3/4”
F1
A1
C1
D1
G1
B1
E1
Allen Wrench
Wire Connector
Plastic Anchor
Wood Screw
Fixture
Cover
Crystal Glass
Junction Box
Screw
Ground Wire
Allen Screw Back Plate
Driver
Junction Box
Mounting
Screw
INSTALLATION INSTRUCTION
LED Wall Sconce