Installation & Safety Instructions

STEP 2
1) Remove the Clevis Pin (8), Nut (9), Spring Washers (11), Flat Washers(12) & Bolt (10) on
Coupling (14).
2) Loosen the Screw (1) from Hanger Ball (3), remove the Hanger Ball (3) and Lock Pin (2).
3) Route the wires and safety wire from the motor through the
Downrod
(7).
4) Install the
Downrod
(7) to Coupling (14) and secure with Bolt (10), Flat Washer (12), Spring Washer
(11), Nut (9) & Clevis pin (8).
5) Tighten the 2 Set Screws (13) on the Coupling (14) to serve as a clamping force on the
Downrod
(7)
to prevent fan shaking during operation.
6) Route the Coupling cover (6), Canopy Ring (5), Canopy (4) and Hanger Ball (3) through the
Downrod
(7)
in turn, and then install the Lock pin (2) through the hole on the
Downrod
(7). Slip the hanger ball (3)
upward to lock Pin (2), and fix it by Screw (1), then slip down the Coupling Cover (6) in correct position.
7) Remove the stopper(x3) on the top of fan motor.
(10)
(13)
(8)
(11)
(9)
(12)
(7)
(14)
(3)
(7)
(1)
(2)
5
INSTALLATION INSTRUCTION
6
INSTALLATION INSTRUCTION
expansion bolt or self tapping screw and
fix it to the building structure.
4) Place ring of safety wire through the
3) Tighten the safety wire clamp.
STEP 3
5) Connect the wire connector plugs
correctly. The wire connector plugs design
with fool proof device, please don’t force to
plug. Otherwise it may affect the normal use
of the light fan or burn the fan motor.
1) Raise the fan and place the hanger ball onto mounting bracket.
2) Rotate the fan until the notch on hanger ball snapped into the slot on mounting bracket and sits
firmly.
NOTE : THE DOWNROD AND HANGER BALL SHOULD NOT ROTATE IF THIS STEP IS DONECORRECTLY.
Fan
Controller
Safety Wire Clamp