Installation Instructions

H
K
N
L
N
M
G
F
Page 2/2
C
US

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU
LED module replace(Fig.3)
Shut
off power before replacing
1:If the fixture do not work ,replace it as shown in Fig 3.
Make sure the power is off when you replace .
2:Twist-off the finial (G) and disconnect the wires and
save the wire nuts , take the fixture down from the
ceiling carefully;
3:Disconnect the wire nut (K), cut a short section of
cable wire if necessary , be careful not to damage the
other insulation jacket of the inner wire when
stripping bare strands of 1/2".
4:Remove the "8" buckle and take off the cable wire
from the hole of the canopy (F). Unscrew the set
screw (M) with the wrench provided. Save these parts
for subsequent service.
5:Push the spring nut with finger to pull out the 4 metal
cables.
6:Replace the complete fixture body (H) with a new one.
7:Repeat step 5-1 to assemble the fixture .
Your replace is now complete , Re-install the fixture to
the ceiling as shown in Fig.1,return power to the junction
box and text the fixture
Fig.3

READ AND SAVE THESE INSTRUCTIONS
For LED Pendant
INSTALLATION INSTRUCTIONS 