Installation Instructions

ManualsBrandsBrayden Studio ManualsCeiling LightsHayleigh 2-Light LED Unique / Statement Tiered Chandelier

Table Of Contents

Fig.3

Fig.2

FIXTURE

WIRES

BLACK OR

SMOOTH

FIXTURE

WIRES

WHITE OR

RIBBED

FIXTURE

WIRES

GREEN OR

BARE

COPPER

(GROUND)

HOUSE

WIRES

BLACK

(HOT)

HOUSE

WIRES

WHITE

(NEUTRAL)

HOUSE

WIRES

GREEN OR

BARE COPPER

(GROUND)

Page 2/2

LED module replace(Fig.3)

Shut

off power before replacing

1:There have four LED module with this fixture ,in each

up and down of the Body Ring (H ),if each side of the

LED module do not work ,it is need to change the

complete body ring (H) from the canopy ,make sure the

power is off before you replace ;

2:Twist-off the finial (G) and disconnect the wires and

save the wire nuts , take the fixture down from the

ceiling carefully;

3:Disconnect the wire nut (K), cut a short section of

cable wire if necessary , be careful not to damage the

other insulation jacket of the inner wire when stripping

bare strands of 1/2".

4:Remove the "8" buckle and take off the cable wire

from the hole of the canopy (F). Unscrew the set

screw (M) with the wrench provided. Save these parts

for subsequent service.

5:Push the spring nut with finger to pull out the 4 metal

cables.

6:Replace the complete fixture body (H) with a new one.

7:Repeat step 5-1 to assemble the fixture .

Your replace is now complete , Re-install the fixture to

the ceiling as shown in Fig.1,return power to the junction

box and text the fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU

READ AND SAVE THESE INSTRUCTIONS

For LED Pendant

INSTALLATION INSTRUCTIONS